Callinex Intersects 13.0 Meters of 5.7% Zinc Equivalent Mineralization at Nash Creek in New Brunswick

 

Highlights

• Drill hole NC17-260 expanded the Nash Creek Deposit laterally and intersected 13.0m of 5.7% Zn Eq. starting at a depth of 72.0m including 5.0m of 11.8% Zn Eq.;
• High-grade mineralization intersected in hole NC17-260 is open for further expansion to the west and northwest towards the MacMillan Zone; and
• Drill hole NC17-254 intersected 9.0m of 7.7% Zn Eq. at a starting depth of 49.0m and confirmed continuity between the northern expansion of the Nash Creek Deposit.

VANCOUVER, Jan. 29, 2018 /CNW/ - Callinex Mines Inc. (the "Company" or "Callinex") (TSX-V: CNX; OTCQX: CLLXF)  is pleased to announce assay results from three drill holes as part of the recently completed 35 drill hole campaign at the Company's 100% owned Nash Creek Project located within the Bathurst Mining District of New Brunswick (See Figures 1, 2 and 3). All three drill holes intersected significant mineralization with two of the holes intersecting high-grade, near-surface zinc mineralization. Drill hole NC17-260 expanded the Nash Creek Deposit laterally and intersected 13.0m of 5.7% zinc equivalent mineralization ("Zn Eq.") starting at a depth of 72.0m including 5.0m of 11.8% Zn Eq. (See Table 1).

Drill hole NC17-254 was completed to confirm continuity between the northern expansion of the Nash Creek Deposit and the extent of the current mineral resource (See Figure 3). This hole intersected 9.0m of 7.7% Zn Eq. at a starting depth of 49.0m and demonstrated a robust zone of mineralization with all samples grading in excess of 4.0% Zn Eq.

High-grade mineralization intersected in hole NC17-260 is open for further expansion to the west and northwest towards the MacMillan Zone (See Figure 3). The MacMillan Zone is interpreted to be located along a mineralized fault that also hosts the Hayes Zone located 1 km to the south. The MacMillan Zone is one of five mineralized zones at the Nash Creek Project, two of which host the current mineral resource estimate (See Table 2).

The most significant results from limited drilling at the MacMillan Zone were reported to include^*:

• DDH #11 - 8.5m of 7.1% Zn Eq. (6.5% Pb, 0.9% Zn and 22.6 g/t Ag);
• DDH #12 - 6.2m of 10.5% Zn Eq. (6.5% Pb, 3.4% Zn and 46.3 g/t Ag); and
• CM-2 - 8.5m of 7.1% Zn Eq. (3.3% Zn, 3.8% Pb, 20.0 g/t Ag) and 8.8m of 5.4 Zn Eq. (3.2% Zn, 2.0% Pb and 20.3 gt Ag).

*The drill results are historic in nature and should not be relied upon. The Company relied on previous assessment reports from Falconbridge and has not carried out its own QA/QC on these results.  Even though these results are not necessarily indicative of the mineralization in this zone, the Company believes that the historical drill results identify a key target for further drilling activity.  See Table 1, Note 1 for zinc equivalent calculation.

Three north-striking vertical faults appear to be a pathway for mineralization at the Nash Creek Project. The Peacock Fault appears related to the Hayes Zone and the Chickadee Fault appears to be related to the Hickey Zone. The Peacock Fault has only had one hole drilled between the Hayes and MacMillan Zones and is one of several high-priority targets at the property that will be drill tested in 2018.

The Project benefits from tremendous infrastructure within close proximity. The Nash Creek Deposit is located approximately 1 km from Provincial Highway 11, high-voltage transmission lines and only 25 km by road to Glencore's Brunswick Smelter, deep water port, railway and power plant near the town of Belledune (See Figures 1 and 2). Callinex is currently working towards publishing an updated resource estimate and maiden Preliminary Economic Assessment ("PEA").

J.J. O'Donnell, P.Geo, a qualified person under National Instrument 43-101 and VP of Exploration for Callinex, has reviewed and approved the technical information in this news release.

Figure 1: Map of the Bathurst Mining District of New Brunswick

Figure 2: Plan Map of the Nash Creek Deposit

Figure 3: Plan Map of the Nash Creek Deposit Expansion Holes

Figure 4: Cross Section View of Reported Drill Holes

Table 1: Nash Creek Drill Results

Table 2: 2016 Mineral Resource Estimates for the Nash Creek and Superjack Projects

 

 Table 3: NQ Diamond Drill Hole Data

 

QA/QC

Individual samples were labeled, placed in plastic sample bags, and sealed. Groups of samples were then placed in security sealed bags and shipped directly to SGS Canada Inc in Garson, Ontario for preparation then onto Burnaby, BC for analysis. Samples were crushed to 75% passing 2mm and pulverized to 85% passing 75 microns in order produce a 250g split. All copper, zinc and silver assays were determined by Aqua Regia digestion with a combination of ICP-MS and ICP-AES finish, with overlimits (>100 ppm Ag, >10,000 ppm Zn, and >10,000 ppm Cu) completed by fire assay with gravimetric finish (Ag) or Aqua Regia digestion with ICP-AES finish (copper and zinc). All samples were analyzed for gold by Fire Assay of a 30 gram charge by AAS, or if over 10.0 g/t were re-assayed and completed with a gravimetric finish. QA/QC included the insertion and continual monitoring of numerous standards and blanks into the sample stream at a frequency of 1 per 10 samples, and the collection of duplicate samples at random intervals within each batch at a frequency of 1 per 10 samples.

SGS Canada Inc carried out some or all of following methods to obtain the assay results for Callinex: G_LOG02 Pre-preparation processing, G_WGH79 Weighing and reporting, G_PRP89 Weigh, dry, crush, split, pulverize, G_SCRQC QC for crush and pulverize stages, G_CRU22 Crush >3kg, G_DRY11 Dry samples, GE_FAA313 @Au, FAS, AAS, 30g-5ml (Final mode), GE-IC14A Aqua Regia digestion/ICP-AES finish, GE_IMS14B Aqua Regia digestion/ICP-MS package, GE_IMS14 Aqua Regia digestion, GO_FAG303 30g, Fire assay, gravimetric finish (Au)(Final Mode), GO_FAG313 30g, Fire assay, gravimetric finish (Ag)(Final Mode), G0_ICP13B Ore Grade, Aqua Regia digest/ICP-AES. Ag >10ppm was analyzed by ICP and GO_XRF77B-pyrosulfate fusion.

About Callinex Mines Inc.

Callinex Mines Inc. (TSX-V: CNX ; OTCQX: CLLXF) is advancing its portfolio of zinc rich deposits located in established Canadian mining jurisdictions. The portfolio is highlighted by its Nash Creek and Superjack deposits in the Bathurst Mining District of New Brunswick. Callinex is actively drilling these projects in support of an updated resource estimate and maiden PEA planned for Q2 2018.

Additionally, Callinex is actively exploring its projects in the Flin Flon Mining District of Manitoba which notably include the Pine Bay and Big Island Projects. These projects are located within 25 km to an operating processing facility that requires additional ore within four years.

Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.

Some statements in this news release contain forward-looking information. These statements include, but are not limited to, statements with respect to future expenditures. These statements address future events and conditions and, as such, involve known and unknown risks, uncertainties and other factors which may cause the actual results, performance or achievements to be materially different from any future results, performance or achievements expressed or implied by the statements. Such factors include, among others, the ability to complete the proposed drill program and the timing and amount of expenditures. Except as required under applicable securities laws, Callinex does not assume the obligation to update any forward-looking statement.

SOURCE Callinex Mines Inc.

View original content: http://www.newswire.ca/en/releases/archive/January2018/29/c8594.html